Jump to content

Hose barb

From Wikipedia, the free encyclopedia
(Redirected from Hose barb fitting)
Cross section of a Büchner flask. Note the hose barb pointing right for attaching a vacuum source.
Aspirator with a hose barb
on the right arm
A copper aspirator. The water inlet and outlet are at the top and bottom, respectively; the air inlet is on the side.
At the top of the picture we can see a dozen hose barbs (brass).

Hose barbs are cylindrical pieces or parts for attaching and securing of hoses (tubing). The barb-like rings on the cylindrical piece allow for an easy push-connection of flexible-plastic or rubber tubing that is not so easily disconnected. Hose barbs are used in machine perfusion and chemistry laboratory equipment. Hose barb fittings are small curved, bent or T-shaped pipes, hoses or tubes with hose barbs on at least one side used to join two or more pieces of piping (hosing, tubing) together.[1] Hose barbs are commonly used in the agriculture industry to connect anhydrous ammonia (NH3) hoses. [2]

See also

[edit]

References

[edit]
  1. ^ "An Introduction to Hose Barbed Fittings" (PDF). Brookhaven National Laboratory. Colder Products Company.
  2. ^ "NH3 (Anhydrous Ammonia) Hose Barbs". Continental NH3.
[edit]