Sauer Valley Bridge (Wasserbillig)
Sauer Valley Bridge | |
|---|---|
 | |
| Coordinates | 49°44′0″N 6°30′7.5″E / 49.73333°N 6.502083°E |
| Carries | A1 (Luxembourg) A64 (Germany) |
| Crosses | Sauer valley |
| Official name | Sauertalbrücke |
| Characteristics | |
| Material | Steel and concrete |
| No. of spans | 6 |
| History | |
| Construction start | 1984 |
| Opened | 1987 |
| Location | |
 | |
The Sauer Valley Bridge is a motorway (Autobahn) bridge high above the Sauer River which at this point marks the frontier between Luxembourg and Germany. It was constructed between 1984 and 1987.[1]
The bridge is 1,195 m (3,920.6 ft) long[1] and, at the lowest point of the valley, 98 m (321.5 ft) above the valley floor. Viewed from above it is formed as a curve with a radius of 2,000 m (6,561.7 ft). Additionally, the road surface has a constant 1% gradient. The girder bridge was built with a single superstructure for both carriage ways, and is positioned approximately a kilometer to the north of Wasserbillig in Luxembourg.
Superstructure[edit]
The bridge has a steel superstructure of a constant level underpinned by a continuous support. The longest span between support pillars is 150 m (492.1 ft), which is the span crossing the river. On the Luxembourg side, traveling from west to east, the other span widths are 75 m (246.1 ft), 90 m (295.3 ft) and 125 m (410.1 ft). Two more spans on the German side are of 90 m (295.3 ft) and 75 m (246.1 ft).
The lateral profile of the bridge deck comprises a single box section 27 m (88.6 ft) and an Orthotropic deck inclined at 3.8%. The horizontal profile of the support floor is 8.87 m (29.1 ft) wide. There is therefore a difference between the thicknesses of the two sides of the bridge support which is 5 m (16.4 ft) on the inner side of the road's curvature, and 5.34 m (17.5 ft) on the outer side.
Construction[edit]
Construction of the superstructure took place in 68 section. Each section was delivered as eight segments. The steel of the superstructure used the incremental launch method, employing a machine using 21 pushing devices. In order to be able to use this method over the long spans of the bridge without the need for temporary supports from below, a 58 m (190.3 ft) high cable bearing moving pylon was employed, mounted on the road deck and set 120 m (393.7 ft) back from the tip of the slowly advancing structure.[1]
References[edit]
- ^ a b c Eric Sakowski. "Sauertal Bridge / Sauertalbrücke". Retrieved 26 September 2015.
Further reading[edit]
- Ernst-Günther Nieschalk: Fertigung der Querträger für die Sauertalbrücke. In: Stahlbau 12, Jahrgang 1986, P. 353–355.
- Walter Klein: Montage der Sauertalbrücke im Taktschiebeverfahren. In: Stahlbau 12, Jahrgang 1986, P. 356–360.