Jump to content

Lincoln Road–Pine River Bridge

Coordinates: 43°22′45″N 84°49′59″W / 43.37917°N 84.83306°W / 43.37917; -84.83306
From Wikipedia, the free encyclopedia
Lincoln Road–Pine River Bridge
Bridge undergoing testing after construction
Lincoln Road–Pine River Bridge is located in Michigan
Lincoln Road–Pine River Bridge
Lincoln Road–Pine River Bridge is located in the United States
Lincoln Road–Pine River Bridge
Nearest citySeville, Michigan
Coordinates43°22′45″N 84°49′59″W / 43.37917°N 84.83306°W / 43.37917; -84.83306
Arealess than one acre
Built1922 (1922)
Built byWalter Willets
ArchitectMichigan State Highway Dept.
Architectural styleArched through girder bridge
MPSHighway Bridges of Michigan MPS
NRHP reference No.99001516[1]
Added to NRHPDecember 9, 1999

The Lincoln Road–Pine River Bridge, also known as the Riverdale Bridge, was a bridge located on Lincoln Road over the Pine River near Seville, Michigan. The architect behind the Lincoln Road–Pine River Bridge was the Michigan State Highway Department and its builder was Walter Willets. The bridge is notable for being a large early example of an arched through girder bridge in Michigan, and for sitting on substantially skewed abutments.[2] It was listed on the National Register of Historic Places in 1999.[3]

History

[edit]

The Michigan State Highway Department first designed an arched through girder bridge in 1921, and built the first of them over the River Raisin at Tecumseh.[4] Later versions of the design followed; among the earliest was this bridge over the Pine River. The bridge was constructed for the M-46 trunkline[2] and designated number 291402.[4] In October 1921 the state contracted Walter Willets to construct the bridge. The bridge was completed the following year at a total cost of $18,186.15.[4]

The bridge eventually suffered from severe spalling, and in 2009 it was demolished and replaced.[2]

Description

[edit]

The 1922 Lincoln Road–Pine River Bridge had a single main span stretching 90 feet (27 m).[4] The bridge was 26 feet (7.9 m) wide with a roadway width of 20 feet (6.1 m). It was constructed using two arched concrete through girders which sat on brackets projecting from concrete abutments. Twelve concrete floor beams ran between the girders to support the roadway. The sides of the bridge featured recessed panels and five arched cutouts.[4] The bridge served in essentially unaltered condition until it was demolished.

References

[edit]
  1. ^ "National Register Information System". National Register of Historic Places. National Park Service. July 9, 2010.
  2. ^ a b c "Lincoln Road Bridge". www.historicbridges.org. Retrieved December 20, 2013.
  3. ^ "MICHIGAN - Gratiot County". National Register of Historical Places. Retrieved 21 December 2013.
  4. ^ a b c d e "Lincoln Road/Pine River Bridge". Michigan State Housing Development Authority: Historic Sites Online. Archived from the original on December 20, 2013. Retrieved December 13, 2013.
[edit]