Jump to content

Talk:Admittance parameters

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia

Wrong Y-equivalent?

[edit]

It seems to me that figure 5 in the article is wrong and the correct form is:

Can someone check it please? Thanks. Dalba 19:11, 2 March 2014 (UTC)[reply]

That looks quite similar - except that you have labelled the shunt elements with their admittance, whereas Fig. 5 labels them with their impedance. Are there other important differences? --catslash (talk) 00:48, 3 March 2014 (UTC)[reply]
Not really, but this is the first time I see y11 is used to denote impedance (while at the same figure y21 is admittance?). Dalba 07:17, 3 March 2014 (UTC)[reply]
The picture above is better than that in the article because
  • An immitance is conventional labelled by either its impedance or admittance as appropriate, so taking the reciprocal is redundant and Y11 and Y22 are preferred here.
  • The shunt elements should be shown as general admittances/impedances rather than as resistors.
  • The currents I1 and I2 should be labelled.
  • The external voltage sources are not part of the thing described and so should not be shown.
  • Circuit diagrams should use vector graphics (e.g. .svg) rather than raster graphics (e.g. .png).

However neither the ground symbols nor the dotted ground connection are required, since the Y-matrix says nothing about these. Overall, File:Two-Port Y-parameters Norton equivalent.svg is the better. --catslash (talk) 21:00, 3 March 2014 (UTC)[reply]