Jump to content

Talk:Candlepower

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia


Article is Incorrect and Deliberately Misleading (2022)

[edit]

As of 2022/2023, this article is almost entirely incorrect &/or misleading. In particular:

  • The term candlepower was a standardized technical term. The term "candela" did not replace it; instead, 'candlepower' was redefined (by the IEEE and the ANSI-IES Standard) to be expressed in candelas. (The older term "candles" (a.k.a. "international candles"), on the other hand, was replaced by 'candelas'.)
<quote>"candlepower (cp)- In illuminating engineering and television engineering: Luminous intensity expressed in candelas." </quote>::

[source: IEEE Standard Dictionary of Electrical and Electronics Terms (3rd Ed., 1984), et al.]

<quote> "The units of measure for Beam Candlepower (Bcp) are Candela, Distance (D) in Feet, and Intensity (Fc) in Foot-candles.</quote>::

Make no mistake, this article -- from the picture to the way most of it was written -- was (almost certainly) part of a deliberate effort by a subgroup of editors of Wikipedia (e.g. the Measurement "project") to make the "SI" system the only acceptable way to define measurements, in part by depreciating and invalidating any other measurement systems (regardless of specialized field)--often through misrepresentation. (I make this assertion because I watched it happen during the 2000s.) --Libertas (talk) 07:58, 24 December 2022 (UTC)[reply]

Calibration of lamps

[edit]

I doubt that there is a direct relation between the cp value and lm value of a light source? Because there is no direct relation between the cd and lm. And the cp value is a factor of the cd value. But using cd (or cp) for the description of a source is not adequate. The cd that light source emits depend on the angle of the measure. If you measure perpendicular to the filament, then the value will be higher than measured from the side. So my question is: what use does the cp value have? I know it's an obsolete unit. But it is still used: http://www.pmlights.com/bulbs.cfm --TeakHoken193.187.211.118 (talk) 12:03, 5 November 2008 (UTC)[reply]

I found the answer: http://www.donsbulbs.com/cgi-bin/r/d.pl/cp.html ; http://www.donsbulbs.com/cgi-bin/r/d.pl/mean_spherical_candlepower.html . Seems that MSCP can be converted into lm.--TeakHoken193.187.211.118 (talk) 14:49, 5 November 2008 (UTC)[reply]

Measuring Candlepower

[edit]

Should we have Anyway, I'm no math whiz, but from what I can tell, the following procedure could be used to verify the candlepower output of a flashlight. (Many consumer flashlights are rated in candlepower, but what consumer can test them?)

Since 1 candlepower is one lumen per steradian, and a steradian is equal to the radius of a sphere squared, and a lumen is the total quantity of light ("photons per second") emitted by a standard candle in one steradian, then we know that if we put a piece of paper 1 foot from a candle, it will be illuminated with 1 lumen per square foot. So this will be our reference.

So let's say our flashlight is rated at 1000,000 candlepower -- we take the square root of that (which is 1000) and we place the flashlight 1000 feet away from our candle.

We then set up a light shield so that the candle (from 1 foot away) shines on one half of a piece of paper, and the light from the flashlight (1000 feet away) shines on the other half --- then we can see which is brighter. They should be equal, if the flashlight is really 1,000,000 candlepower.

You see, at 1000 foot, the area (in square feet) of one steradian will be a million square feet. Thus, the one square foot will be one millionth of a steradian, so if the paper target is illuminated with one lumen per square foot, (which we compare to the candle that also delivers one lumen per square foot at one foot), we then see that the flashlight delivers 1 lumen over one square foot -- which is one millionth of a steradian -- so, since candlepower=lumens/steradians, we divide the 1 lumen by the millionth of a steradian and get 1000000 for the candlepower rating..

Am I all wrong? Could be. But at the moment this makes sense to me. Jesse 65.249.55.64 (talk) 09:18, 5 March 2011 (UTC)[reply]

Candle image relevance

[edit]

Is the picture without caption relevant to this article, or should it be removed? The information I get from the picture is just: "this is what a candle looks like". — Preceding unsigned comment added by SuperSpaceAdventure (talkcontribs) 06:58, 12 October 2012 (UTC)[reply]

It implies to me that a candle such as the one in the image is a 1 candlepower source, which is approximately true. JMiall 12:10, 12 October 2012 (UTC)[reply]
[edit]

Hello fellow Wikipedians,

I have just modified one external link on Candlepower. Please take a moment to review my edit. If you have any questions, or need the bot to ignore the links, or the page altogether, please visit this simple FaQ for additional information. I made the following changes:

When you have finished reviewing my changes, you may follow the instructions on the template below to fix any issues with the URLs.

This message was posted before February 2018. After February 2018, "External links modified" talk page sections are no longer generated or monitored by InternetArchiveBot. No special action is required regarding these talk page notices, other than regular verification using the archive tool instructions below. Editors have permission to delete these "External links modified" talk page sections if they want to de-clutter talk pages, but see the RfC before doing mass systematic removals. This message is updated dynamically through the template {{source check}} (last update: 5 June 2024).

  • If you have discovered URLs which were erroneously considered dead by the bot, you can report them with this tool.
  • If you found an error with any archives or the URLs themselves, you can fix them with this tool.

Cheers.—InternetArchiveBot (Report bug) 05:31, 30 July 2017 (UTC)[reply]