Talk:Signal averaging

Electronics Low‑importance

	Electronics portal This article is part of WikiProject Electronics, an attempt to provide a standard approach to writing articles about electronics on Wikipedia. If you would like to participate, you can choose to edit the article attached to this page, or visit the project page, where you can join the project and see a list of open tasks. Leave messages at the project talk pageElectronicsWikipedia:WikiProject ElectronicsTemplate:WikiProject Electronicselectronic articles
Low	This article has been rated as Low-importance on the project's importance scale.

According to the top paragraph, by averaging several signals "...S/N, will be increased, ideally in proportion to the square root of the number of measurements", which is indeed a common conclusion.

However, according to the calculations below and using the given definition of SNR as the power of the signal over the noise variance, averaging n signals increases the S/N by n, not the square root of n: "...averaging n realizations of the same, uncorrelated noise reduces noise power by a factor of n."

I believe the statement that the SNR is increased by the square root of n arises from using the RMS of the signal over the RMS of the noise as the definition of SNR, rather than the power. Perhaps this could be clarified.

2600:1702:2DD0:C4C0:97C:E50:637E:B5EA (talk) 23:44, 19 August 2018 (UTC)[reply]