User:SamC99/sandbox
Alpine skiing, or downhill skiing, is the sport or recreation of sliding down snow-covered hills on skis with fixed-heel bindings. It is characterized by the requirement for mechanical assistance getting to the top of the hill, since the equipment does not allow efficient walking or hiking, unlike cross-country skis which use free-heel bindings. It is typically practiced at ski resorts which provide services such as ski lifts, artificial snow making and grooming, first aid, and restaurants. Back-country skiers use alpine skiing equipment to ski off the marked pistes, in some cases with the assistance of snowmobiles, helicopters or snowcats. Alpine skiing has been an event at the Winter Olympic Games since 1936 (except for the 1940 games)[1].
Contents
[edit][[null hide]]
Stemming
[edit]Carving
[edit]Skis
[edit]Bindings
[edit]Boots
[edit]Helmets
[edit]Participants and venues[edit]
[edit]As of 1994, there were estimated to be 55 million people worldwide, who engaged in Alpine skiing. Approximately 30 million of these were in Europe, 15 million in the US, and 14 million in Japan. As of 1996, there were reportedly 4,500 ski areas, operating 26,000 ski lifts and enjoying skier visits. The preponderant region for downhills skiing was Europe, followed by Japan and the US.[2]
Technique[edit]
[edit]Alpine ski slopes in San Carlos de Bariloche (Argentina)
A skier following the fall line will reach the maximum possible speed for that slope. A skier with skis pointed perpendicular to the fall line, across the hill instead of down it, will accelerate more slowly. The speed of descent down any given hill can be controlled by changing the angle of motion in relation to the fall line, skiing across the hill rather than down it.
Downhill skiing technique focuses on the use of turns to smoothly turn the skis from one direction to another. Additionally, the skier can use the same techniques to turn the ski away from the direction of movement, generating skidding forces between the skis and snow which further control the speed of the descent. Good technique results in a flowing motion from one descent angle to another one, adjusting the angle as needed to match changes in the steepness of the run. This looks more like a single series of S's than turns followed by straight sections.
Stemming[edit]
[edit]Main article: Stem (skiing)
The oldest and still common form of alpine ski turn is the stem, turning the front of the skis sideways from the body so they form an angle against the direction of travel. In doing so, the ski pushes snow forward and to the side, and the snow pushes the skier back and to the opposite side. The force backwards directly counteracts gravity, and slows the skier. The force to the sides, if unbalanced, will cause the skier to turn.
Carving[edit]
[edit]Main article: Carve turn
Carving is based on the shape of the ski itself; when the ski is rotated onto its edge, the pattern cut into its side causes it to bend into an arc. The contact between the arc of the ski edges and the snow naturally causes the ski to tend to move along that arc, slowing the skier and changing their direction of motion.
![](http://upload.wikimedia.org/wikipedia/commons/thumb/0/03/Skier-carving-a-turn.jpg/220px-Skier-carving-a-turn.jpg)
The turning snowplow is the simplest form of turning and is usually learned by beginners. To perform the turning snowplow one must be in the snowplow position while going down the ski slope. While doing this they apply more pressure to the inside of the opposite foot of which the direction they would like to turn. This type of turn allows the skier to keep a controlled speed and introduces the idea of turning across the fall line. Side slip/turning uphill: When learning to turn uphill a skier must learn how to side slip. They begin by skiing across the fall line, while skiing across the fall line they must push their ski facing the downhill side of the slope. This will cause the ski to begin to skid, when the ski skids the skier shifts their weight towards the skidding ski causing them to make a 180 degree turn towards the other direction of the fall line. These actions in a sequence are the basic method of carving while skiing. To perform an uphill turn one does the side slip method, but instead of shifting their weight over their skidding ski, they turn their skis upwards, which will cause them to stop. This method is used to slow down or stop while skiing on a slope. [3]
Equipment[edit]
[edit]A collection of differing types of alpine skis, with Nordic and telemark skis at far left. From right: a group of powder skis, a group of twin-tip skis, a group of carving (parabolic) skis, and then an older-type non-sidecut alpine ski along with the non-alpine skis.
Skis[edit]
[edit]Main article: Ski § Alpine
Modern Alpine skis are shaped to enable carve turning, and have evolved significantly since the 1980's, such as, Powder skis, Freestyle skis, All-Mountain skis, Kids skis and more. Powder skis are usually used when there is a large amount of fresh snow. The reason being is the shape of a powder ski is wide allowing the ski to float on top of the snow compared to a normal downhill ski which would most likely sink into the snow. Freestyle skis are used by skiers who ski terrain parks. These skis are meant to help a skier who skis jumps, rails, and other features placed throughout the terrain park. Freestyle skis are usually fully symmetric, meaning they are the same dimensions from the tip of the ski to the backside of the ski. All mountain skis are the most common type of ski, All mountain skis tend to be used as a typical alpine ski. All Mountain skis are built to do a little bit of everything, they can be used in fresh snow (powder) or used when skiing groomers. Slalom Race Skis, or usually referred to as race skis are short narrow skis. These skis are usually on the stiffer side of rank because they are meant for those who want to go fast as well as make quick sharp turns. [4]
Bindings[edit]
[edit]Main article: Ski binding § Alpine
The binding is a device used to connect the skier’s boot to the ski. The purpose of the binding is to allow the skier to stay connected to the ski, but if the skier falls the binding can safely release them from the ski to prevent injury. There are two types of bindings: the heel and toe system (step in) and the plate system binding.
History
During the 1930s, the Kandahar binding was introduced, which could be locked down at the heel for the downhill portions. In the late 1930’s a skier by the name of, Hjalmar Petterson Hvam, suffered a leg injury from skiing. While recovering he created a new model for the ski binding. In this model it “allowed the foot to be fixed to the ski during normal maneuvers but release in the event of a fall.” This new model was called “Saf-Ski” and was brought into the ski industry in 1939. In 1948, a new model of the ski binding was introduced causing the “Saf-Ski” model to be abandoned. The new binding was created by, Jean Beyl. This binding was designed so that it could make a 360 degree turn when the boot was released in an event of a fall. The binding would then return back to the center of the ski. Beyl’s model and Hvam’s model were both contributors to the more recent ski model bindings, such as the “Duplex” toe and the step in binding.[5]
Boots[edit]
[edit]Main article: Ski boot § Alpine
![](http://upload.wikimedia.org/wikipedia/commons/thumb/e/ec/Flexon_ski_boot_evolution.jpeg/220px-Flexon_ski_boot_evolution.jpeg)
Ski boots are one of the most important accessories to skiing. They connect the skier to the skis allowing them full control over the ski. When ski boots first came about they were made of leather and laces were used. The leather ski boots started off as low cut, but gradually became taller as injuries became more common allowing for more ankle support. Eventually the tied laces were replaced with buckles and the leather boots were replaced with plastic. This allowed the bindings to be much more closely matched to the fit of the boot, and offer dramatically improved performance. The new plastic model contained two parts of the boots: inner boot and outer shell. The inner part of the boot (also called the liner) is the cushioning part of the boot and contains a footbed along with cushion to keep a skier’s foot warm and comfortable. The outer shell is the part of the boot that is made of plastic and contains the buckles. Most ski boots contain a strap at shin level to allow for extra strength when tightening the boots. [6]
Helmets[edit]
[edit]Main article: Ski helmet
The purpose of ski helmets are to reduce the chances of getting a head injury while skiing. Ski helmets also help to provide warmth to the head since they consist of an inner liner that traps warmth. [7] Helmets are available in many styles, and typically consist of a hard plastic/resin shell with inner padding. Modern ski helmets may include many additional features such as vents, earmuffs, headphones, goggle mounts, and camera mounts.
Competition[edit]
[edit]Elite competitive skiers participate in the FIS Alpine World Ski Championships, the World Cup, and the Winter Olympics. Broadly speaking, competitive skiing is divided into two disciplines:
- Racing, comprising slalom, giant slalom, super giant slalom, combined, and downhill.
- Freestyle skiing incorporates events such as moguls, aerials, halfpipe, and skicross.
Other disciplines administered by the FIS but not usually considered part of alpine is speed skiing and grass skiing.
Ski trail ratings[edit]
[edit]Main article: Piste § Ratings
In most ski resorts, the runs are graded according to comparative difficulty so that skiers can select appropriate routes. The grading schemes around the world are related, although with significant regional variations. Skiers should be careful to gauge the range of trail difficulty of the mountain they are skiing and select trails rated to their ability accordingly. A beginner-rated trail at a large mountain may be more of an intermediate-rated trail on a smaller mountain. Ski trails are measured by percent slope, not degree angle. In the United States, there are 3 rating symbols: Easy (green circle), Intermediate (blue square), and Difficult (black diamond). Ski trail difficulty is measured by percent slope, not degree angle. A 100% slope is a 45 degree angle. In general, beginner slopes (green circle) are between 6% and 25%. Intermediate slopes (blue square) are between 25% and 40%. Difficult slopes (black diamond) are 40% and up. However, this is just a general "rule of thumb." Although slope gradient is the primary consideration in assigning a trail difficulty rating, other factors come into play. A trail will be rated by its most difficult part, even if the rest of the trail is easy. Ski resorts assign ratings to their own trails, rating a trail compared only with other trails at that resort. Also considered: width of the trail, sharpest turns, terrain roughness, and whether the resort regularly grooms the trail.
Safety[edit]
[edit]The most common types of ski injuries injure the knee, head, neck and shoulder area, hands and back. Staying in shape will help prevent skier’s from injury. Before skiing an individual should workout and stay in shape to avoid any type of injury. Ski helmets are highly suggested by professionals as well as doctors. Head injuries caused in skiing can lead to death or permanent brain damage. Another way to stay safe while skiing, is to ski at your own ability. Skier’s should know what skill level their skiing is at and should ski the runs that suit their capability. [8] In alpine skiing, for every 1000 people skiing in a day, on average between two and four will require medical attention. Most accidents are the result of user error leading to an isolated fall.
- ^ "The 1940 Tokyo Games: The Missing Olympics: Japan, the Asian Olympics and the Olympic Movement | Reviews in History". www.history.ac.uk. Retrieved 2017-11-16.
- ^ LLC, Revolvy,. ""Downhill skier" on Revolvy.com". www.revolvy.com. Retrieved 2017-11-16.
{{cite web}}
: CS1 maint: extra punctuation (link) CS1 maint: multiple names: authors list (link) - ^ Karl., Gamma, (1992). The handbook of skiing (Rev. and updated ed.). New York: Knopf. ISBN 9780679743163. OCLC 25632229.
{{cite book}}
: CS1 maint: extra punctuation (link) CS1 maint: multiple names: authors list (link) - ^ "Skis - Ski Equipment - Mechanics of Skiing". www.mechanicsofsport.com. Retrieved 2017-11-14.
- ^ "A look at the history of ski bindings". Avaunt Magazine. 2017-02-13. Retrieved 2017-11-14.
- ^ Karl., Gamma, (1992). The handbook of skiing (Rev. and updated ed.). New York: Knopf. ISBN 9780679743163. OCLC 25632229.
{{cite book}}
: CS1 maint: extra punctuation (link) CS1 maint: multiple names: authors list (link) - ^ "Ski Helmets Guide - Ski Equipment - Mechanics of Skiing". www.mechanicsofsport.com. Retrieved 2017-11-14.
- ^ "Follow These Tips to Stay Safe While Skiing on the Slopes". ThoughtCo. Retrieved 2017-11-14.